Home l Sitemap l Contact Us
 
 
 
  Home
  About Us
  Products & Specifications
  Manufacturing
  Investor Relations
  Enquiry
  Contact Us
 
3rd Floor, 15-16 Jawahar Marg,
Old IDA Building
Indore - 452 007 (M.P.) INDIA
E-Mail : shares@siddhart.com
Telephone : (0731) 4789300, 4789328
Telefax : (0731) 4789301
 
  MANUFACTURING PROCESS
 
H.R. Slitting
The hot rolled sheets in coil form, which is the basic raw material, are slit in the required width on H.R. Slitter having rotary knives and then coiled back in different width of slit coils before being subjected to the Tube Mill.
 
Tube Mill
Slit coils of suitable size and specification are fed to Pinch Roll and Flattener with the help of uncoiler followed by guide unit and profile rolls to form tube which is finally welded by high frequency welder. :

Slit coils of suitable size and specification are fed to Pinch Roll and Flattener with the help of uncoiler followed by guide unit and profile rolls to form tube which is finally welded by high frequency welder.

 
End Facing
Black pipes are end faced for deburring the ends of pipes.
 
Hydro Testing Machine
Pipes are tested as per specification to the required test pressure as per ISI. NDT sprayed pipes are tested for pressure leakage. If pipes have pressure leakage, the same will be rejected. Pipes are tested as per specification to the required test pressure as per ISI. NDT sprayed pipes are tested for pressure leakage. If pipes have pressure leakage, the same will be rejected.
 
Threading Machine
After the above process depending on orders whether to supply as plain or threaded, pipes are threaded as per specification.
 
Galvanising
Pipes manufactured are dipped in degreasing tanks for removal of oil and grease and then rinsed in water tank. After this pipes are dipped in Pickling tank containing hydrochloric acid to remove rust and again rinsed in water. From here, pipes are dipped in flux tank containing ammonium zinc chloride and then dried in furnace. These chemically pre treated pipes are finally dipped in molten zinc bath for galvanizing. After removing pipes from the bath, outer and inner surface of pipes are steam blown to remove excess zinc for uniform coating and then passed through chromic passivation for increasing life of the coating. :

Pipes manufactured are dipped in degreasing tanks for removal of oil and grease and then rinsed in water tank. After this pipes are dipped in Pickling tank containing hydrochloric acid to remove rust and again rinsed in water. From here, pipes are dipped in flux tank containing ammonium zinc chloride and then dried in furnace. These chemically pre treated pipes are finally dipped in molten zinc bath for galvanizing. After removing pipes from the bath, outer and inner surface of pipes are steam blown to remove excess zinc for uniform coating and then passed through chromic passivation for increasing life of the coating.

 
Packing
The manufactured pipes are then either bundled or kept in loose condition as per specific requirement of customer before despatch.

The manufactured pipes are then either bundled or kept in loose condition as per specific requirement of customer before despatch.

TOP
© 2011 Siddhartha Tubes Ltd. All Rights Reserved. Site Designed by : emperor-solutions